CarbonX CF PC/ABS

$68.00

Description

CarbonX™ Carbon Fiber Reinforced PC/ABS Filament

CarbonX™ CF-PC/ABS has been formulated to offer improved thermal resistance and mechanical properties while retaining an ease of printability that makes it ideal for anyone seeking a structural component with high heat, high stiffness, excellent surface quality, and dimensional stability.

If you have a dual extruder, the AquaTek® X1 Water Soluble Support works great with CarbonX™ CF-PC/ABS and allows you to print parts with complex geometries and then dissolve away the support in warm water.

Recommended Print Conditions:

  • Extruder:  280-300°C
  • Bed Temp:  100-120°C
  • Bed Prep:  3Dlac Spray, PEI Sheet or tape, Kapton/PI Tape, Glue stick on clean glass, ABS/Acetone Slurry
  • Nozzle: We strongly recommend a 0.4mm orifice or larger using one of our A2 Hardened Nozzles – HERE
  • Layer Height:  Ideal layer height is 60% of nozzle diameter.  We do not recommend printing layers below 0.25mm with carbon fiber grades.  Lower than 0.25mm may create too much back pressure in the hot end and result in poor feeding, jams, drive gear clicking, and eating a notch into the filament.

Additional information

Weight .75 kg
Dimensions 33 × 33 × 10 cm
Filament Diameter

1.75mm

Volume

750 grams